Two Step Authentication

Rolled Alloys expanded its processing capabilities with the addition of an Andritz Herr-Voss Stamco coil leveling line. The machine will allow the company to process material from 020 to .125 inch. The line can receive coils up to 20,000 pounds with widths from 24 to 48 inches wide. It is also capable of adding PVC protection to the top and bottom of sheets for stringent surface requirements.Get more news about coil leveling,you can vist our website!

Rolled Alloys, a supplier of stainless steels and nickel and titanium alloys, recently expanded its Temperance, Mich., facility. It now has greater capacity and new processing capabilities. For example, Rolled Alloys has the ability to cut sheets up to 180 inches long. If you are looking for flat material, coil stock can be tough. While high-volume manufacturers may have their own equipment to flatten the coils and process them into thin sheets, often you are at the command of the pattern size and amount of pre-packaged rather than being able to order what you need. The leveling and blanking process or cut to length line is responsible for this. We TX machinery has the ability to process a wide variety of flat rolled products for you, no matter how big or small your order needs.

Leveling

Leveling is the process by which the coil is unfolded and cut to length. Depending on the material type, common pattern or sheet sizes are 24 “, 36 “, 48 “, 60 “and 72” wide, 96 “, 120 “or 144” long. Because of the memory function of metal coils, there are many problems related to the flat sheets when producing flat sheets. Leveling lines usually have rollers, which will help relieve some of the stress on the material.

Blanking

Blanking is just another term for flat. It usually refers to a custom size that will help you minimize the fragmentation or flat challenges that schema tables often impose. Usually, the material will be cut to the custom width you want and cut into smaller “metal plates” that can be easily handled and increase the productivity of your project.

Cut to length

Another term for the leveling or blanking process is cut to length. In some cases, this procedure indicates that no additional measures have been taken to reduce the stress of the coil material prior to cutting it into thin slices. The practice is most common in soft materials, which are more ductile and can be “work hardened” if too much pressure is applied to the rollers during leveling or blanking.

Which one do you need?

Now that you know more about the shear length of metal blanking and rolled products, your next step is to keep a close eye on the finished product you want. When a purchase order or blank, you need to consider price, availability, and volume. In many cases, metal blanks are worth an extra few cents per pound because of the better scrap loss. Working with a service centre to produce the quantity you need and know your end users can avoid big trouble.