Two Step Authentication

When ceramic tiles china have been selected as the most appropriate for a particular project, the next step is to ensure that they are properly installed. A significant proportion of Italian tiles is made up of large-format tiles with side lengths greater than 60 cm (square tiles) or 80 cm (rectangular tiles). Large-format tiles with side lengths greater than 60 cm or 80 cm (rectangular tiles) are particularly important in this regard.

In terms of project success, it is fair to say that the installation of floor or wall tiling is the single most important factor, particularly given the fact that this type of surface typically lasts for decades as a result of its technical and aesthetic characteristics.

Read more: How to use and combine each color depending on your personal style

In order to ensure that the installation work is completed by a qualified tile layer, as previously mentioned, the following advice should be followed: Because there are no mandatory certifications for tile layers, it is critical to hire a tile layer who has the necessary skills and qualifications, even though this is common sense and applies to any type of manual labor.

If there are any specific requirements for the project, the tile layer should be made aware of them as quickly as possible. It is only through the use of a highly skilled professional that these requirements can be met, and it is through their advice that the most effective method of installation can be determined and implemented." In addition, having a clear and honest exchange of ideas with the designer or architect can be beneficial to them.

While this article does not attempt to cover every step of the installation process, it does make a few critical recommendations that should not be overlooked.
1. When installing large-scale tiles, adhesive should be applied to both the substrate and the back of the tile (the so-called back-buttering technique) in order to ensure maximum bonding and to prevent the formation of air bubbles beneath the tiles. 2. Straight parallel lines of adhesive should be applied to both the substrate and the back of the tile in a straight, straightforward manner on both sides of the tile. It is recommended that after the ceramic tile has been installed, it be tamped with a vibrating mechanical plate in order to ensure that the tile, adhesive, and substrate make the greatest possible contact.

2. Because the edges of large-size ceramic tiles have been rectified, they can be installed in such a way that they form a continuous, seamless surface, which has significant aesthetic and functional advantages. It is important to remember that even though a jointless installation appears to be the case, it is not always the case, as tiles online should never be installed with joint widths of less than 2 mm, as this will result in a distorted appearance (the minimum width specified as mandatory by Italian standard UNI 11493).

Following that, the joint must be filled with grout to a depth equal to or greater than two-thirds the thickness of the tile (although more is preferable), with any excess grout being carefully removed. The use of grout that is the same color as the tile helps to create a surface that has an appealing seamless appearance, which is particularly appealing.
4. Command and control, as well as the ability to expand
Using joints, you can keep the movements of the various components of the structure separated from one another as much as possible (concrete slab, screed, adhesive, and tile, for example). Following the specifications of the technical standard, the joints in interior tiling should technically divide the floor into squares or rectangles with a side length ratio of no more than 1.5, according to the technical standard. The squares or rectangles can be any size between 5 5 metres in width and length and 6 4 metres in width and length.
The provision of perimeter joints whenever the floor meets other surfaces (such as walls), regardless of their orientation, is also recommended.
6. A thorough cleaning of the entire installed surface, including the joints, should be performed. When all remnants of the installation materials have been removed from the area where the work is being done, the installation is considered complete.
The integration of radiant heating systems into so-called floating screeds, which is a solution that is currently very popular, is number 7. The screed above the coils must have a minimum thickness of 30 millimeters in order to comply with the standard requirements (mm). Prior to the installation of the tiles, it is recommended that the heating system be subjected to a test cycle.